◆ steam curing: new molded pole with a touch of static pole stopped for some time into the steam curing chamber, conservation hours ◆ stripping and conservation: pole with a mold out of the curing room, stripping concrete electric pole, clean mold, off moisture or mold poles continue to flood damage mold curing period greater investment, productivity depends on the mold turnover. To keep the distance between the wires. Low-voltage wire or cable installation substandard concrete pole installation unreasonable wholesale, resulting in wire and cable too close to concrete poles, wire and cable insulation and even some direct contact, due to disrepair or due to prolonged friction, wire insulation aging or broken, so that may cause the charged wire, resulting in leakage or even personal electric shock. Such cases often occur before. According clearance distance "10kV and below overhead distribution lines design technical specification" DL / T5220-2005 of 9.0.12 "distribution line of wire and cable, not less than the following values: 1 ~ 10kV to 0.2m, 1kV following is 0.1m ". This low-power requirements and the provisions of 0.05m technical regulations are in conflict, but according to the order issued on the high principles and not to low, still using "10kV overhead distribution lines below design rules" requirement. Kyushu Electric Power tower (Figure) | Concrete Poles Wholesale | pole provided by Henan Kyushu Electric Power Tower LLC. "Transmission Line Steel Tower, reinforced concrete cement poles, power tower" preferred Henan Kyushu Electric Power Tower Co., Ltd. (2), the company is located: Henan Anyang industry gathering area south of South rings over the years, Kyushu Electric Power tower adhere to the customers provide the best quality service, contact: Manager Zhou. Welcome to the new and old customers call, letter, visit the guide, business negotiations. Kyushu Electric Power tower expect to be your long term partner!